용어 사전-NEWARE - 배터리 테스터 - 배터리 테스트 장비

Glossary

하드웨어

테스트 설비 환경 시험 챔버 자동화 라인 부품 보조 모듈 Others
소포트웨어

BTS BTSDA Others

Hardware Module

Product Features

Product Parameters

State of charge (SOC)

It is used to reflect the current capacity of the battery and can be expressed as percentage ratio of the current capacity and rated capacity
Plateau capacity

The corresponding capacity value when the voltage reaches the set plateau voltage.
Plateau time

The corresponding time when the voltage reaches the set plateau voltage.
Active material

The cathode/anode material, which attends the current formation reaction (electrochemical reaction process).
Current upper limit

The channel will be protected when the current of the present step is greater than or equal to the set value
Current lower limit

The channel will be protected when the current of the present step is less than or equal to the set value.
Voltage upper limit

The channel will be protected when the present step voltage is greater than or equal to the value set by the upper voltage limit.
Voltage lower limit

The channel will be protected when the present step voltage is less than or equal to the value set by the upper voltage limit.
Press upper limit

The channel will be protected when the press of the present step is greater than or equal to the set value.
Press lower limit

The channel will be protected when the press of the present step is less than or equal to the set value.
Capacity upper limit protection

The channel will be protected when the capacity of the present step is greater than or equal to the set value.
Expression

A formula consisting of numbers, operators, and variables.
Expression voltage

Take the value of the expression as the limited value of the voltage.
Expression current

Take the value of the expression as the limited value of the current.
Voltage median

The Voltage at half capacity.
Recovery voltage

When the channel is resumed, the voltage of the final data in the previous step.
Open circuit voltage（OCV)

Terminal voltage of battery in open circuit state.
Reset mapping

Rearrange the channels and display them on the software interface.
Priority mapping

The unassigned auxiliary channels are assigned to the selected main channel in priority.
Super mapping

The channels of multiple control units are mapped to the same interface.
Jump

Terminate the present step and jump to the selected step.
Move

Move the unfinished test to another channel.
Single start

Manually start the selected channel.
Cycle

Make the step run repeatedly between the selected steps.

쿠키 사용 주의사항

당사는 쿠키를 사용하여 귀하의 웹사이트 이용 경험을 개인화하고 개선합니다. 사이트를 계속 탐색하면 쿠키 사용에 동의하게 됩니다.

동의